Hardware Installation Checklist
Order Equipment: DST will order required equipment after stores sign a price quote. Price Quotes can be obtained from DST. For pricing information refer to Sig_Cap_Price List.asp
1. Install Linux Server
a. When Signature Server arrives on site call DST for installation steps.
2. Install stands for Signature Capture pads (optional) at counter.
a. Remove stands from packaging.
b. Remove top of stand by pulling top while holding base.
c. Push cord with connection to pad through bottom of base. You can drill a hole through the counter or run the cord through the channel in the base of the stand.
d. Determine best position of stand considering customer accessibility and cable connections. Mount stands by screwing four screws into the counter.
e. Replace top of stand.
f. Mount the signature pad on the stand by lining up the mounting holes over the three screws on the stand.
g. Once pad is in place, there is a screw that needs to be hand tightened to secure the signature pad to the stand.
3. Install LCD Signature Capture pads at counter
a. Remove LCD from package.
b. Mount LCD to stand or to counter (See section #2 above)
c. Plug the cable into the back of the LCD pad.
d. Plug the other end of the cable into the serial port on the back of the PC that the invoices will be entered on.
e. Plug the power transformer into 120V outlet.
f. Plug other end of the power cord into the hole on the serial cable that is plugged into the serial port on the PC.
4. Install Printers
NOTE: Instructions are only for the recommended HP LaserJet
a. Remove from package and install toner and load paper tray per the manufacturer instructions.
b. Plug in power and plug in network cable to data jack, switch or hub.
c. Assign printer an IP address (follow steps in section #5)
5. Setting up Printer IP Address
a. Decide on an IP address for this printer. An address will also be required for Subnet Mask and Gateway. Call DST for assistance if you do not have the required IP information.
b. On the front of the printer push the green button to enter setup.
c. Push the down arrow until CONFIGURE DEVICE is highlighted and then press the green button.
d. Push the down arrow until I/O is highlighted and then press the green button.
e. Push the down arrow until EIO* is highlighted and then press the green button.
f. Push the down arrow until TCP/IP is highlighted and then press the green button.
g. Push the down arrow until CONFIG METHOD is highlighted and then press the green button.
h. Push the down arrow until MANUAL is highlighted and then press the green button.
i. Push the down arrow until IP ADDRESS is highlighted and then press the green button.
j. The next screen that appears looks like an IP address. For instance 192.168.44.70 (this is only an example, your IP address may look different). The next steps require you to push the up or down arrow and select the green button for each section of the IP address. For instance, press the down arrow until 192 and then press the green button, press down arrow until 168 and then press the green button, press down arrow until 44 appears then press the green button, press the down arrow until 70 appears and then press green button.
k. Push down arrow to SUBNET MASK and press green button. Follow instructions in step J to complete this process. NOTE: Most Subnet Masks are 255.255.255.0.
l. Push down arrow until DEFAULT GATEWAY and press green button. Follow instructions in step J to complete this process. NOTE: In most cases the Default Gateway will be the IP address of your internet router.
The Signature Capture Hardware is now setup. The next step is to install the Signature Capture software. Contact Database Support if you don't already have an implementation date scheduled for the software installation.
NEXT --->
Signature Capture DBS Software Documentation
|
